Dell PowerEdge C6220 II Hardware Owners Manual - Page 189

Installing the LSI 9265-8i RAID Battery Assembly 1 Attach the LSI9265-8i RAID battery assembly onto the LSI9265-8i RAID battery tray. See Figure 3-34. 2 Tighten the screw securing the LSI9265-8i RAID battery assembly. See Figure 3-34. 3 Connect the cable connecting to the LSI 9265-8i card. 4 When replacing the LSI9265-8i RAID battery assembly for 1U node, skip to step 7; for 2U node, continue the steps. 5 Replace the interposer-extender tray. See "Removing the Interposer Extender Tray" on page 160. 6 Replace the interposer extender for 2U node. See "Removing the Interposer Extender for 2U Node" on page 158. 7 Install the system-board assembly. See "Installing a System-Board Assembly" on page 150. Removing the LSI 9265-8i RAID Battery CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. NOTE: The information in this section applies only to systems with the optional RAID controller card. 1 Remove the system-board assembly. See "Removing a System-Board Assembly" on page 149. 2 Disconnect the cable connecting to the LSI 9265-8i card. 3 When removing the LSI 9265-8i RAID battery for 1U node, skip to step 6; for 2U node, continue the steps. 4 Remove the interposer extender for 2U node. See "Removing the Interposer Extender for 2U Node" on page 158. 5 Remove the interposer-extender tray for 2U node. See "Removing the Installing System Components | 189