Dell PowerEdge M520 Dell PowerConnect M6220/M6348/M8024 Switches Configuration - Page 71
Example 1: Configuring VRRP on the Switch as a Master Router,
View all Dell PowerEdge M520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Figure 4-2. VRRP Example Network Configuration Layer 3 Switch acting as Router 1 Layer 3 Switch acting as Router 2 VPLoArtN1/500/2 192.150.2.1 Virtual Router ID 20 Virtual Addr. 192.150.2.1 PVoLrAt 1N/06/40 192.150.4.1 Virtual Router ID 20 Virtual Addr. 192.150.2.1 Layer 2 Switch Hosts Example 1: Configuring VRRP on the Switch as a Master Router Enable routing for the switch. IP forwarding is then enabled by default. console#config console(config)#ip routing Configure the IP addresses and subnet masks for the VLAN routing interfaces that will participate in the protocol, for example: console(config)#interface vlan 50 console(config-if-vlan50)#routing console(config-if-vlan50)#ip address 192.150.2.1 255.255.255.0 console(config-if-vlan50)#exit Enable VRRP for the switch: console#config console(config)#ip vrrp Routing Configuration 71