Dell PowerEdge M520 Dell PowerConnect M6220/M6348/M8024 Switches Configuration - Page 85
Example #1: Enable Routing for the Switch, Port Routing Example Network Diagram
View all Dell PowerEdge M520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
The PowerConnect M6220/M6348/M8024 switches support both versions of RIP. You may configure a given port: • To receive packets in either or both formats • To transmit packets formatted for RIP-1 or RIP-2 or to send RIP-2 packets to the RIP-1 broadcast address • To prevent any RIP packets from being received • To prevent any RIP packets from being transmitted CLI Examples The configuration commands used in the following example enable RIP on ports vlan 2 and vlan 3 as shown in the network illustrated in Figure 4-6. Figure 4-6. Port Routing Example Network Diagram Layer 3 Switch acting as a router VLAN 3 1921.9P12o3.r1t0310./30.3/.3.11 PVoLrtA1N/0/22 11929.215.10.52.02.2.2 VLAN 5 192.64.4.1 Port 1/0/5 192.64.4.1 Subnet 2 Subnet 3 Subnet 5 Example #1: Enable Routing for the Switch The following sequence enables routing for the switch: console#config ip routing exit Routing Configuration 85