Dell PowerEdge M520 Dell PowerConnect M6220/M6348/M8024 Switches Configuration - Page 86
Example #2: Enable Routing for Ports, Example #3. Enable RIP for the Switch
View all Dell PowerEdge M520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
Example #2: Enable Routing for Ports The following command sequence enables routing and assigns IP addresses for VLAN 2 and VLAN 3. console#config interface vlan 2 routing ip address 192.150.2.2 255.255.255.0 exit interface vlan 3 routing ip address 192.130.3.1 255.255.255.0 exit exit Example #3. Enable RIP for the Switch The next sequence enables RIP for the switch. The route preference defaults to 15. console#config router rip enable exit exit Example #4. Enable RIP for the VLAN Routing Interfaces This command sequence enables RIP for VLAN 2 and VLAN 3. Authentication defaults to none, and no default route entry is created. The commands specify that both interfaces receive both RIP-1 and RIP-2 frames, but send only RIP-2 formatted frames. console#config interface vlan 2 ip rip ip rip receive version both ip rip send version rip2 exit interface vlan 3 ip rip ip rip receive version both ip rip send version rip2 exit exit 86 Routing Configuration