Dell PowerEdge M710 Fabric OS Command Reference Manual Supporting Fabric - Page 170

2 configure Zoning Operation Parameters Table 9 lists the configurable zoning operation parameters. TABLE 9 Zoning operation parameters Field Type Default Disable NodeName Zone Checking Boolean 0 Range 1 Disable NodeName Zone Checking Specify 1 to disable using node WWN when specifying nodes in the zone database, or specify 0 to enable using node WWN when specifying nodes in the zone data. The default value is 0. This value must be set to 1 for interpretability. RSCN Transmission Mode Table 10 lists the RSCN transmission mode values fields. TABLE 10 RSCN transmission modes Field End-device RSCN Transmission Mode Domain RSCN to End-device for switch IP address or name change Type number number Default 1 0 Range 0 to 2 0 to 1 End-device RSCN Transmission Mode values are as follows: 0 RSCN only contains single PID 1 RSCN contains multiple PIDs 2 Fabric addresses RSCN Domain RSCN to End-device for switch IP address or name change values are as follows: 0 Disabled. No domain RSCN is sent to the end-device for the switch IP address or name change. 1 Enabled. Domain RSCN is sent to the end-device for the switch IP address or name change. Arbitrated Loop Parameters The Arbitrated Loop Setting fields are described in Table 11. TABLE 11 Configure command arbitrated loop settings Field Default Send FAN frames? 1 Enable CLOSE on OPEN received? 4 Always send RSCN? 0 Range 0 or 1 0 to 4 0 or 1 Descriptions of the Arbitrated Loop Parameter fields are as follows: Send FAN frames? Specifies that fabric address notification (FAN) frames be sent to public loop devices to notify them of their node ID and address. When set to 1, frames are sent; when set to 0, frames are not sent. 138 Fabric OS Command Reference 53-1001764-02