Dell PowerEdge M710 Fabric OS Command Reference Manual Supporting Fabric - Page 646
Brocade 7800 switch. The two 10GbE ports on the Brocade FX8-24 blade are
View all Dell PowerEdge M710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 646 highlights
2 portCfg --disable --enable The syntax for portCfg mirrorport is as follows: portcfg mirrorport [slot/]port mode Valid modes for mirrorport are: Disables the configuration. When disabled, a port cannot be a mirror port. Enables the configuration. When the mirror port feature is enabled to a port, a mirror connection can use this port to mirror traffic. Examples To enable a mirror port configuration: switch:admin> portcfg mirrorport 2/4 --enable Please confirm enable of Mirror Port (Y,y,N,n): [n] y To configure a range of ports as RSCN-suppressed: switch:admin> portcfg rscnsupr 2/4-7 --enable Function Synopsis Commands supported on the Brocade 7800/FX8-24 and the Brocade 7500/7500E/FR4-18i platforms portcfg action [slot/] ge_port arguments Description Use this command to configure the local IP interfaces and static routes on the Brocade 7800/FX8-24 and on the Brocade 7500/7500E/FR4-18i platforms. You must configure the local IP interfaces before you can create and configure FCIP tunnels. In Fabric OS v6.3.1 and later, you can also create a VLAN configuration at the IP interface on the Brocade 7800/FX8-24. The configuration procedures described in this section are essentially the same. • portcfg ipif - Configure the local IP interfaces. • portcfg iproute - Configure a static route on the IP interface. • portcfg vlantag - Manage the IP interface VLAN configuration for FCIP. Operands This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). ge_port Specifies the number of the GbE port to be configured. The GbE ports are numbered ge0 - ge9 on the Brocade FX8-24 blade and ge0 - ge5 on the Brocade 7800 switch. The two 10GbE ports on the Brocade FX8-24 blade are numbered xge0 and xge1. The two GbE ports on the Brocade 7500/7500E, and FR4-18i are numbered ge0 and ge1. Use the switchShow command for a list of valid ports. ipif Defines the IP interface for both ports of a tunnel. On the Brocade 7800 and FX8-24, up to eight IP interfaces per GbE port are supported, but only 4 FCIP circuits can be configured on a single GbE port. Up to 10 IP interfaces and 10 FCIP circuits are supported on the 10GbE port. On the Brocade 7500/7500E/FR4-18i, up to eight IP interfaces per GbE port are supported. The IP network connection is configured by defining IP interfaces for origin and destination virtual ports, and then defining one or more IP routes to connect them. The syntax for portCfg ipif is as follows: 614 Fabric OS Command Reference 53-1001764-02