Dell PowerEdge M710 Fabric OS Command Reference Manual Supporting Fabric - Page 784

2 portShow Perm Net App Network-wide permanent entry. The same as the permanent entry except that no destination address was defined (defaults to 0.0.0.0), so traffic to all destinations is tagged. Application layer VLAN configuration defined at the circuit level. Examples To display the IP interface and static route configured on Brocade 7800: switch:admin> portshow ipif ge0 Port: ge0 Interface IPv4 Address NetMask Effective MTU Flags 0 192.168.0.20 255.255.255.0 1500 U R M 1 192.168.0.21 255.255.255.0 1500 U R M Interface IPv6 Address Len Effective MTU Flags 2 fe80::205:1eff:fec3:e6b2 64 1500 U R M 3 2000::20 64 1500 U R M 4 2000::21 64 1500 U R M 5 2000::22 64 1500 U R M Flags: U=Up B=Broadcast D=Debug L=Loopback P=Point2Point R=Running N=NoArp PR=Promisc M=Multicast S=StaticArp LU=LinkUp switch:admin> portshow iproute ge0 Port: ge0 IP Address Mask Gateway Metric Flags 192.42.0.0 255.255.255.0 192.168.0.250 0 U G 192.168.0.0 255.255.255.0 * 0 U C 192.168.0.10 255.255.255.255 * 0 U H L 192.168.0.11 255.255.255.255 * 0 U H L 192.168.0.21 255.255.255.255 * 0 U C 192.168.0.250 255.255.255.255 * 0 U H L IPv6 Address Len Gateway Metric Flags 2000:: 64 * 0 U C 2000::10 128 * 0 U H L 2000::11 128 * 0 U H L 2000::1:250 128 * 0 U H L 2001:: 64 2000::1:250 0 U G fe80:: 64 * 0 U C ff01:: 32 * 0 U C ff02:: 32 * 0 U C Flags: U=Usable G=Gateway H=Host C=Created(Interface) S=Static L=LinkLayer(Arp) 752 Fabric OS Command Reference 53-1001764-02