Dell PowerEdge M710 Fabric OS Command Reference Manual Supporting Fabric - Page 709
Displays the IP interface for both ports of the tunnel. IPv6 addresses are
View all Dell PowerEdge M710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 709 highlights
portCfgShow 2 Operands This command supports the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). port Specifies the number of the port to be displayed, relative to its slot for bladed systems. Use switchShow for a listing of valid port numbers. -i index1[-index2] Specifies a port or a range of ports identified by port index numbers. You can specify multiple index ranges separated by a space, for example, -i 33-38 40-60. -f -slot slot1[-slot2] ge_port Ignores nonexisting ports. This operand is valid only with the -i option. Specifies a slot or a range of slots. You can specify multiple slot ranges separated by a space, for example, -s 1-3 5-7. Specifies the number of the GbE Port to be displayed. The GbE ports are numbered ge0 - ge9 on the Brocade FX8-24 blade and ge0 - ge5 on the Brocade 7800 switch. The 10GbE ports on the Brocade FX8-24 blade are numbered xge0 and xge1. The GbE ports on the Brocade 7500/7500E, and FR4-18i are numbered ge0 and ge1. Use the switchShow command for a list of valid ports. Use portCfgshow with a GbE port or with one of the following optional arguments to display specific FCIP-related parameters. Displays supported only on the Brocade 7800 /FX8-24 and on the Brocade 7500/7500E/FR4-18i platforms The following operands are optional; if omitted, all of the configuration settings are displayed on the 7500/7500E/FR4-18i platforms, along with the FCIP tunnels. When issued on the Brocade 7800/FX8-24, tunnels and parameters not applicable to these platforms are not displayed. Use the portShow command to display FCIP tunnel and circuit parameters on the Brocade 7800/FX8-24. ipif Displays the IP interface for both ports of the tunnel. IPv6 addresses are supported on the Brocade 7500/7500E/FR4-18i platforms, and on the Brocade 7800/FX8-24 platforms with Fabric OS v6.4.0. iproute Displays the IP route on the specified GbE port. IPv6 addresses are supported. IPv6 addresses are supported on the Brocade 7500/7500E/FR4-18i platforms, and on the Brocade 7800/FX8-24 platforms with Fabric OS v6.4.0. arp Displays the address resolution protocol (ARP) table. vlantag Displays the VLAN tagging configuration. For each entry, the output displays the IP interface address, the destination IP address, the VLAN ID, and the L2 CoS priority. This display includes permanent entries only. Permanent entries are configured at the IP interface level with the portCfg vlantag command. To view VLAN tagged tunnels and circuits along with permanent entries, use the portShow vlantag command. fciptunnel Displays FCIP tunnels and related parameters. Valid arguments for fciptunnel include: all Displays information for all FCIP tunnels. Fabric OS Command Reference 677 53-1001764-02