Dell PowerEdge M710 Fabric OS Command Reference Manual Supporting Fabric - Page 961
switchShow, Switch state: Online, Offline, Testing, or Faulty. If
View all Dell PowerEdge M710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 961 highlights
switchShow 2 switchShow Displays switch and port status. Synopsis switchshow switchshow [-slot slot] -portname switchshow [-portcount |-iscsi] Description Use this command to display switch, blade, and port status information. Output may vary depending on the switch model. When used without operands, switchShow displays the following information: switchName Switch name. switchType Switch model and revision numbers. switchState Switch state: Online, Offline, Testing, or Faulty. If switchcfgPersistentDisable is issued and thereafter followed by switchEnable, then the switch state changes to, "Online (Temporary)". The switch remains in this state until switchcfgPersistentEnable is issued. switchMode Switch operation mode: Native, Interop, or Access Gateway. switchRole Switch role: Principal, Subordinate, or Disabled. DomainIDOffset Domain ID Offset, displays only on switches in interop mode 2 and 3. Valid values for this field are: 0x00, 0x20, 0x40, 0x60, 0x80, 0xA0, 0xC0, and 0xFF. The 0xFF value indicates 239 domain offset mode and is applicable only to interop mode 3. Refer to interopMode for more information. switchDomain Switch domain ID: 0-31 or 1-239. switchId Switch embedded port D_ID. switchWwn Switch world wide name (WWN). switchBeacon Switch beaconing state: On or Off. zoning The name of the active zone is displayed in parentheses. Active only when Access Gateway mode is disabled. FC Router FC Router state: On or Off. FC Router BB Fabric ID The backbone fabric ID for FC routing. Allow XISL Use Allows the switch to use interswitch links (XILS) in the base fabric to carry traffic to this logical switch. Values are ON or OFF. LS Attributes On a switch in Virtual Fabric mode, this field displays logical switch attributes, including the fabric ID associated with the logical switch, the switch role (default switch or base switch), and the fabric Address Mode (0, 2 or 3). If Virtual Fabrics are disabled, only the Address Mode is displayed. The fabric Address Mode value is set by the configure command (Enable a 256 Area Limit). The switch summary is followed by one-line description for non-EX_Ports and one or two lines for EX_Ports: Fabric OS Command Reference 929 53-1001764-02