Dell PowerEdge M710 Fabric OS Command Reference Manual Supporting Fabric - Page 805
Displays FCIP TCP Byte Stream statistics on Byte Stream-enabled tunnels.
View all Dell PowerEdge M710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 805 highlights
portShow 2 -credits Displays FC data path credit data. -ipsec Displays IKE and IPSec policy information on IPSec-enabled tunnels. Security policies are configured with the portCfg command. -qosmap Displays the mapping table for VC to FCIP QoS. -bstr Displays FCIP TCP Byte Stream statistics on Byte Stream-enabled tunnels. -hist Displays the history of TCP connections. -snapstart Resets TCP statistics. The collection of the statistics restarts when this command is executed. It ends when the -snapshow option is executed. -snapshow Displays the TCP statistics that were collected since startup or since the statistics were reset with the -snapshow command. iscsi Displays GbE port WWN and ISCSI Sessions. mode Displays mode of GbE port as either "FCIP" or "not configured". ficon Displays FICON emulation configuration parameters. The syntax for tportshow ficon is as follows: portshow ficon [Slot/] ge_port all | tunnel_Id [arg] [parm] [-clear] The following arguments are supported with ficon: -globals Displays general FICON controls and statistics. -images Displays discovered Images (FCUB). -emul Displays emulated FDCBs. -active Displays active FDCBs. -epcb Displays Emulation Control Block (port specific). -fhpb -fdpb adrs Displays FICON Host Path Block. Displays FICON Device Path Block. -fchb Displays FICON Channel Control Block. -fcub -fdcb adrs -mem adrs Displays FICON Control Unit Control Block. Displays FICON Device Control Block. Displays memory in 256-byte increments: ! for next. -pools Displays current data buffer pool counts. -pmmr Displays PMMR pointers. -fastw Displays the FastWrite queue. -clear Clears post-display statistics; requires a preceding argument. inbandmgmt Displays the status of the inband management configuration and IP addresses configured to enable inband management on the Brocade 7500 through GbE port interfaces. This command requires a port to be specified and displays the IP addresses for that port. In addition the output shows whether inband management is enabled or disabled. To display the routing table, use the portshow iproute command. Fabric OS Command Reference 773 53-1001764-02