Dell PowerEdge M710 Fabric OS Command Reference Manual Supporting Fabric - Page 88
format for specifying the port number., Specify the port number. On enterprise-class platforms
View all Dell PowerEdge M710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
2 authUtil authinit [slot/]port [, [slot]/port...| allE Reinitiates authentication on selected ports after changing the DH-CHAP group, hash type, and shared secret between a pair of switches. This command does not work on Private, Loop, NPIV and FICON devices. The command can reinitiate authentication only if the device was previously authenticated. This command may bring down the E_Ports if the DH-CHAP shared secrets are not installed correctly. Valid options include: slot Specify the slot number, if applicable, followed by a slash (/). port Specify the port number. On enterprise-class platforms, use the slot/port format for specifying the port number. allE Specify all E_Ports in the switch. Examples To display authentication configuration on the switch: switch:admin> authutil --show AUTH TYPE HASH TYPE GROUP TYPE fcap,dhchap sha1,md5 0,1,2,3,4 Switch Authentication Policy: PASSIVE Device Authentication Policy: OFF To set DH-CHAP as the authentication protocol: switch:admin> authutil --set -a dhchap Authentication is set to dhchap. To set both protocols in order of FCAP and then DH-CHAP: switch:admin> authutil --set -a all Authentication is set to fcap,dhchap. To set DH group 3: switch:admin> authutil --set -g 3 DH Group was set to 3. To set all DH groups to be specified in the authentication negotiation in the order of 0, 1, 2, 3, and 4: switch:admin> authutil --set -g "*" DH Group is set to 0,1,2,3,4 To set the Switch policy to active mode: switch:admin> authutil --policy -sw active Warning: Activating the authentication policy requires either DH-CHAP secrets or PKI certificates depending on the protocol selected. Otherwise, ISLs will be segmented during next E-port bring-up. ARE YOU SURE (yes, y, no, n): [no] y Auth Policy is set to ACTIVE 56 Fabric OS Command Reference 53-1001764-02