Dell PowerEdge M710 Fabric OS Command Reference Manual Supporting Fabric - Page 349
Specifies the Channel ID CHID. The CHID is the Logical Partition LPAR, ficonCupShow, Examples
View all Dell PowerEdge M710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 349 highlights
ficonCupSet 2 CRP PID CHID PID CHID Sets the current reporting path (CRP). The reporting path is a CUP mechanism for sending FRU-failure reports to a FICON logical path via FICON protocol. The logical path between the PID and the CHID must exist and be in operational state for this command to succeed. Use ficonCupShow with the LP option to display the logical paths on the switch. The following operands are required: Specifies the Port identifier. Specifies the Channel ID (CHID). The CHID is the Logical Partition (LPAR) identifier supplied as part of the FICON protocol header. The format of the CHID is a numerical identifier followed by a letter, for example, 1B. Examples To enable FMS mode for the switch: switch:admin> ficoncupset fmsmode enable fmsmode for the switch is now Enabled To set the ASM bit in the mode register for the switch: switch:admin> ficoncupset modereg ASM 1 Active=Saved Mode bit is set to 1 To set the MIHPTO value to 60 seconds: switch:admin> ficoncupset MIHPTO 60 MIHPTO has been changed to 60 seconds To set the current reporting path: switch:admin> ficoncupset CRP 082300 1A To display the current reporting path: switch:admin> ficoncupshow LP FICON CUP Logical Paths for CUP 0x08FE00 PID -----082300 082300 082300 082400 082400 612400 612400 LP CHID ---1A 1B 1C 1A 1B 1E 1F Reporting State ---Oper*** Oper Oper Reset Reset Reset Reset Path -----Curr Prim See Also ficonCupShow Fabric OS Command Reference 317 53-1001764-02