Dell PowerEdge M710 Fabric OS Command Reference Manual Supporting Fabric - Page 671
portCfgAutoDisable
View all Dell PowerEdge M710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 671 highlights
portCfgAutoDisable 2 portCfgAutoDisable Name Synopsis Enables or disables the port autodisable flag. portcfgautodisable --enable [slot/]port[-port] portcfgautodisable --disable [slot/]port[-port] Description Use this command to enable or disable the autodisable feature for a specified port or a range of ports. If the ports are already in the requested configuration, no action is taken. If a range of ports is specified, some of which are already in the requested configuration, a notification is generated, and no action is taken for those ports only. All other ports in the specified range are updated. Execution of this command is nondisruptive. The default behavior of the autodisable feature is to be disabled for all ports unless you specifically enable the feature. When executed without operands, this command displays the usage. Use the portCfgShow command to determine if the port autodisable flag is on or off. The port autodisable feature minimizes traffic disruption introduced in some instances when automatic port recovery is performed. When the autodisable flag is set, the specified ports disable automatically under any conditions that would cause the port to reinitialize. Such conditions include loss of sync, loss of signal, OLS, or NOS. Note that a link reset does not cause a port autodisable. When a port is in FICON Management Server (FMS) mode, an autodisabled port remains persistently disabled across HA failover. In all cases, the automatically disabled port may be brought back into service using the portEnable command. Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. The Fabric OS port configuration commands are not supported on FCoE ports. Operands This command has the following operands: --enable --disable slot port[-port] Enables the autodisable feature on the specified ports. Disables the autodisable feature on the specified ports. Specifies the slot number on bladed systems, followed by a slash (/). Specifies a port or a port range, relative to the slot number on bladed systems, for example, 5/17-29. Examples To enable the autodisable feature on a single port: switch:admin> portcfgautodisable --enable 1 To enable the autodisable feature on a port, on which this feature is already enabled: switch:admin> portcfgautodisable --enable 8 Same configuration for port 8 To enable the autodisable feature on a port range. switch:admin> portcfgautodisable --enable 0-8 Fabric OS Command Reference 639 53-1001764-02