Dell PowerEdge M710 Fabric OS Command Reference Manual Supporting Fabric - Page 668
to display existing, routes. Use
View all Dell PowerEdge M710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 668 highlights
2 portCfg Operands This command has the following operands: inbandmgmt Configures IP addresses and routes for the CP or GbE port inband management interfaces. Inband management allows a management station to communicate with the CP through GbE ports. Valid options and arguments for inbandmgmt are: ipaddrset cp | ge ip_address netmask Configures the IP address and netmask for a CP or a GbE inband management interface. This command requires specifying the type of interface (cp or ge), an IPv4 address, and the subnet mask. For each management interface, configure two IP addresses, one for the CP and one for the GbE port. ipaddrdel cp | ge ip_address Deletes the IP address for a CP or GE inband management interface. Specify the type of interface (cp or ge) and the IPv4 address to be deleted. cp | ge Specifies the interface type as either CP or port processor. This operand is required when configuring or deleting an IP address. ip_address Specifies the IP address for the inband management interface. The IP address must be in IPv4 format, followed by the subnet mask. IPv6 addresses are not supported. This operand is required with the ipaddrset and ipaddrdel options. netmask Specifies the subnet mask for the IP address in a.b.c.d format. This operand is required only with the ipaddrset option. routeadd destination netmask [gateway] Adds a route to the management station for an existing CP or GbE port (CP or GbE designation is made automatically). You must specify the destination IP address and the subnet mask when adding a management route. You must create the IP addresses for the CP and the GbE port interfaces before you can add a route to the routing table. Use portshow iproute to display existing routes. Use portshow inbandmgmt to display the management interface status and IP addresses. routedel destination netmask Deletes a management route from an internal CP or a GbE port interface. You must specify the destination and the subnet mask when deleting a management route. destination Specifies the destination for the route. This is the IP address of the management station. This operand is required when adding or deleting a route. netmask Specifies the subnet mask. This operand is required when adding or deleting a route. gateway Specifies the gateway IP address. This operand is optional if the destination is in the same subnet as one of the IP interface addresses. If the destination is not part of the same subnet, you must specify a gateway IP address. 636 Fabric OS Command Reference 53-1001764-02