Dell PowerEdge M710 Fabric OS Command Reference Manual Supporting Fabric - Page 824
Displays statistics for all ports on a slot or on a range of slots, for example
View all Dell PowerEdge M710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 824 highlights
2 portStatsShow ip_err_tcp_data_chksum The number of IP TCP data checksum errors observed on the GbE port. Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. This command is not supported on FCoE ports. Operands This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be displayed, followed by a slash (/). [ge]port Displays statistics for a single port identified by the port number, relative to its slot on bladed systems. Specify the optional ge option to display the GbE port hardware statistics. Port ranges are not supported with this command. Use switchShow for a listing of valid ports. -i index1[-index2] Displays statistics for a single port or for a range of ports identified by port index numbers. You may specify multiple index ranges separated by a space, for example, -i 33-47 65-73. -f -slot] [slot1[-slot2] Ignores nonexisting ports. This operand is valid only with the -i option. Displays statistics for all ports on a slot or on a range of slots, for example, -s 3-5. You may specify multiple slot ranges separated by a space, for example, -s 3-5 8-10. ge Displays the GbE port statistics. ip ip_address Displays all GbE port statistics related to IP addresses that are not zero. This operand is not supported on the Brocade 7800 and FX8-24 platforms. Specifies an IP address to display statistics only for the specified IP address. This operand is optional and valid only with the ip option. fcip Displays the GbE statistics on all FCIP tunnels. This operand is not supported on the Brocade 7800 and FX8-24 platforms. tunnel_number Specifies a tunnel ID to display statistics only for the specified FCIP tunnel. This operand is optional and valid only with the fcip option. -h Displays the command usage. Examples To display the basic set of statistics for port 1/13 on a DCX backbone: switch:admin> portstatsshow 13 stat_wtx 0 stat_wrx 0 stat_ftx 0 stat_frx 0 stat_c2_frx 0 stat_c3_frx 0 stat_lc_rx 0 stat_mc_rx 0 stat_mc_to 0 stat_mc_tx 0 tim_rdy_pri 0 tim_txcrd_z 0 4-byte words transmitted 4-byte words received Frames transmitted Frames received Class 2 frames received Class 3 frames received Link control frames received Multicast frames received Multicast timeouts Multicast frames transmitted Time R_RDY high priority Time TX Credit Zero (2.5Us ticks) 792 Fabric OS Command Reference 53-1001764-02