Dell PowerEdge M710 Fabric OS Command Reference Manual Supporting Fabric - Page 674

2 portCfgDefault portCfgDefault Synopsis Resets the port configuration to factory default values. portcfgdefault [slot/][ge]port Description Use this command to reset all configuration values on a specified port to their factory defaults. This command persistently disables ports capable of routing, which is the factory default value. Use the portCfgShow command to display the port configuration. This command does not change the state of a port. To change the state of an E_Port, use either switchDisable/switchEnable or portDisable/portEnable. When issued on a Brocade 8000 in Access Gateway mode, this command resets the buffer limited mode on all N_Ports. It also returns the maximum NPIV per port login limit to the default value of 126 on all ports, including FCoE ports. Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. Operands This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be reset, followed by a slash (/). port Specifies the number of the port to be reset, relative to its slot for bladed systems. Use switchShow to list of valid ports. Examples To reset a port to factory defaults: switch:admin> portcfgdefault 1/3 To reset a GbE port to factory defaults: switch:admin> portcfgdefault 8/ge1 To reset a an FCoE port on a Brocade 8000 in Access Gateway mode: switch:admin> portcfgdefault 13 switch:admin> portcfgshow Area Number: Speed Level: Fill Word: Trunk Port Locked N_Port Persistent Disable LOS TOV enable NPIV capability QOS Port Port Auto Disable: Rate Limit F_Port Buffers NPIV PP Limit: 13 AUTO(HW) 0(Idle-Idle) ON OFF OFF OFF ON AE OFF OFF OFF 126 See Also portCfgEport, portCfgGport, portCfgLongDistance, portCfgLport, portCfgPersistentDisable, portCfgPersistentEnable, portCfgShow, portCfgSpeed, portCfgTrunkPort 642 Fabric OS Command Reference 53-1001764-02