Dell PowerEdge M710 Fabric OS Command Reference Manual Supporting Fabric - Page 645
Manages Registered State Change Notification RSCN suppression on the, action, Using Fabric OS commands
View all Dell PowerEdge M710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 645 highlights
portCfg 2 • "Commands supported only on the Brocade 7500/7500E switches" - portcfg inbandmgmt - Configures IP addresses and routes for the CP or GbE port inband management interfaces. To display the command usage on the switch, execute portcfg action without any further arguments. Notes Beginning with the Fabric OS v6.4.0 release, IPv6 addresses are supported on the Brocade 7800 and FX8-24 platforms. On the Brocade 7500/7500E and FR4-18i, IPv6 addresses are supported on switches running Fabric OS v.6.0 or later. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. Some of the features supported by this command may require a license. The Fabric OS port configuration commands are not supported on FCoE ports. Function Synopsis Commands supported on all platforms portcfg action [slot/]port arguments Description Use this command to configure the following parameters on a local FC port. • portcfg mirrorport - Configure a mirror port on the local port. • portcfg rscnsupr - Manage registered state change notification (RSCN) suppression on the local port. Operands This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). port[-port] Specifies a single port or a range of ports, for example, 3-22 or 1/3-8. port ranges are supported only with the rscnsupr option. rscnsupr Manages Registered State Change Notification (RSCN) suppression on the local port. RSCN suppression is configurable only on FC ports. The syntax for portCfg rscnsupr is as follows: portcfg rscnsupr [slot/]port[-port] mode The following modes are supported with the rscnsupr option: --disable Disables the configuration. When disabled, device changes on the port generate an RSCN to all other end devices that are zoned with this one. By default, RSCN suppression is disabled on all ports. --enable Enables the configuration. When enabled, any device changes on the port will not generate an RSCN to any other end device. mirrorport Configures a mirror port on the local port. The port mirroring feature reroutes data frames between two devices to the mirror port. Port mirroring can aid in troubleshooting common FC end-to-end communication problems. The command prompts for confirmation that the specified port be enabled as a mirror port. Once a port is configured as a mirror port, the port can only be used as part of a mirror connection. Fabric OS Command Reference 613 53-1001764-02