Dell PowerEdge M710 Fabric OS Command Reference Manual Supporting Fabric - Page 993

thConfig 2 FILTER Monitors the Filter Performance Monitor class. Valid areas for the filter class include the following: customer-defined Customer defined performance areas. You can specify any filter monitor to be tracked by Fabric Watch. Refer to the fmConfig command for more information. EE Monitors the End-to-End Performance Monitor class. Valid areas for the EE class include the following: RXP Monitors receive performance as the percentage of word frames traveling from the configured SID to the DID. TXP Monitors transmit performance as the percentage of word frames traveling from the configured DID to the SID. --set class -area area Configures Fabric Watch thresholds for monitoring a specified class and area. When configuring Fabric Watch thresholds, you must specify a class and an area. The following operands are optional and valid only with the --set option; if omitted, the default Fabric Watch configuration is used. Defaults parameters vary depending on the area and platform. Refer to the Fabric Watch Administrator's Guide for specific details. -timebase time_base Specifies the time interval between two samples to be compared. Valid intervals are: day Samples are compared once a day. hour Samples are compared once every hour. minute Samples are compared once every minute. second Samples are compared once every second. none Samples are compared against threshold boundary limit. -highthreshold -value value Specifies the high threshold value for triggering a specified alert action. To change the default value, provide an integer value. -lowthreshold -value value Specifies the low threshold for triggering a specified alert action. To change the default value, provide an integer value. -trigger above | below Specifies the actions for in range behavior. In range is defined as the space above the low threshold and below the high threshold. -action actions Specifies the actions triggered by a configured event condition. Valid values include one or more of the following actions. If more than one action is specified, the actions must be separated by commas. raslog Event triggers a RASlog message. snmp Event triggers an SNMP trap. Fabric OS Command Reference 961 53-1001764-02