Dell PowerEdge T310 Hardware Owner's Manual - Page 156
See General Memory Module Installation Guidelines
View all Dell PowerEdge T310 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 156 highlights
4 Enter the System Setup program and check the system memory setting. See "Memory Settings Screen" on page 61. Make any changes to the memory settings, if needed. If the memory settings match the installed memory but a problem is still indicated, go to step 15. 5 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet. 6 Open the system. See "Opening the System" on page 85. 7 Remove the cooling shroud. See "Removing the Cooling Shroud" on page 88. 8 Check the memory banks and ensure that they are populated correctly. See "General Memory Module Installation Guidelines" on page 108. 9 Reseat the memory modules in their sockets. See "Installing Memory Modules" on page 111. 10 Replace the cooling shroud. See "Installing the Cooling Shroud" on page 89. 11 Close the system. See "Closing the System" on page 86. 12 Place the system upright. 13 Reconnect the system to its electrical outlet, and turn on the system and attached peripherals. 14 Enter the System Setup program and check the system memory setting. See "Memory Settings Screen" on page 61. If the problem is not resolved proceed with the next step. 15 Turn off the system and attached peripherals, and disconnect the system from the power source. 16 Open the system. See "Opening the System" on page 85. 17 If a diagnostic test or error message indicates a specific memory module as faulty, swap or replace the module. 18 To troubleshoot an unspecified faulty memory module, replace the memory module in the first DIMM socket with a module of the same type and capacity. See "Installing Memory Modules" on page 111. 19 Close the system. See "Closing the System" on page 86. 156 Troubleshooting Your System