Dell PowerEdge T310 Hardware Owner's Manual - Page 51

Unsupported CPU, System Services

Get Dell PowerEdge T310 PDF manuals and user guides View all Dell PowerEdge T310 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 51 highlights

Table 1-3. System Messages (continued) Message Causes Unable to launch System Services image. System halted! System halted after F10 keystroke because System Services image is either corrupted in the system firmware or has been lost due to system board replacement. The iDRAC6 Enterprise card flash memory may be corrupted. Unexpected interrupt in protected mode Improperly seated memory modules or faulty keyboard/mouse controller chip. Unsupported CPU combination Unsupported CPU stepping detected Unsupported DIMM detected. The following DIMM has been disabled: x Processor is not supported by the system. Invalid memory configuration. The system will run but with the specified memory module disabled. Corrective Actions Restart the system and update the Unified Server Configurator repository to the latest software to restore full functionality. See the Unified Server Configurator user documentation for more information. Restore the flash memory using the latest version on support.dell.com. See the iDRAC6 user's guide for instructions on performing a field replacement of the flash memory. Reseat the memory modules. See "Troubleshooting System Memory" on page 155. If the problem persists, see "Getting Help" on page 177. Install a supported processor. See "Processor" on page 126. Ensure that the memory modules are installed in a valid configuration. See "General Memory Module Installation Guidelines" on page 108. About Your System 51

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
About Your System
51
Unable to launch
System Services
image. System
halted!
System halted after
F10 keystroke because
System Services image
is either corrupted in the
system firmware or has
been lost due to system
board replacement.
Restart the system and
update the Unified Server
Configurator repository to
the latest software to restore
full functionality. See the
Unified Server Configurator
user documentation for more
information.
The iDRAC6 Enterprise
card flash memory may
be corrupted.
Restore the flash memory
using the latest version on
support.dell.com. See the
iDRAC6 user's guide for
instructions on performing a
field replacement of the flash
memory.
Unexpected
interrupt in
protected mode
Improperly seated
memory modules or
faulty keyboard/mouse
controller chip.
Reseat the memory modules.
See "Troubleshooting System
Memory" on page 155. If the
problem persists, see
"Getting Help" on page 177.
Unsupported CPU
combination
Unsupported CPU
stepping
detected
Processor is not supported
by the system.
Install a supported processor.
See "Processor" on page 126.
Unsupported
DIMM detected.
The following
DIMM has been
disabled:
x
Invalid memory
configuration. The system
will run but with the
specified memory
module disabled.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 108.
Table 1-3.
System Messages
(continued)
Message
Causes
Corrective Actions