Dell Precision Rack 7910 Dell Precision Rack 7910 Owners Manual - Page 56
Installing the riser 1 blank, Removing expansion-card risers
View all Dell Precision Rack 7910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Figure 22. Removing and installing the riser 1 blank 1. slot on the chassis 3. riser 1 blank 2. tab (2) Installing the riser 1 blank 1. Align the blank with the slot on the chassis. 2. Insert it into the chassis until it clicks into place. Removing expansion-card risers CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1. Ensure that you read the Safety instructions. 2. Follow the procedure listed in Before working inside your system. 3. If installed, remove any expansion card installed on riser 2 and 3. NOTE: The expansion-card riser 1 can be used only when both the processors are installed. Holding the slots on the expansion-card riser, lift the riser from the riser connector on the system board. 56