Epson ES-300C User Manual - Page 71
Initialization, Default Settings
View all Epson ES-300C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Initialization There are three ways that the scanner can be initialized (returned to a fixed set of conditions). Hardware initialization: l The power is turned on. l The scanner receives an INIT signal at the parallel interface (pin 31 goes LOW). Software initialization: l The software sends an initialize command. Default Settings The table below shows the default conditions that take effect when the scanner is initialized. Item Data format Resolution 1 Zoom Scanning area 1 Color mode Brightness Halftoning mode Gamma correction Color correction Default 1 bit/pixel 100 dpi for horizontal scan and vertical scan 1 100% for horizontal scan and vertical scan 848 x 1169 dots, no off set 1 Monochrome Center "0" (normal) DIP switch setting DIP switch setting DIP switch setting During initialization, the scanner terminates the scanning operation and returns the carriage to the home position (at the back of the scanner). Technical Specifications A-7