HP 3500 HP Color LaserJet 3500 and 3700 Series Printers - User Guide - Page 131

Note If the old transfer unit was not at end-of-life when it was replaced (for example, if it was damaged), or if you want to continue printing past the end-of-life message, the transfer kit count must be reset using the printer control panel. Please note that the end-of-life message is provided as a customer service, and printing past it is likely to result in print quality degradation in the near future. Once the transfer kit count has been reset after an end-of-life message, feedback on the kit's remaining life will be incorrect until the kit is replaced and the count is reset again. To reset the transfer unit count 1. Press MENU to enter the MENUS. 2. Press to highlight Configure Device. 3. Press to select Configure Device. 4. Press to highlight RESETS. 5. Press to select RESETS. 6. Press to highlight RESET SUPPLIES. 7. Press to select RESET SUPPLIES. 8. Press to highlight NEW TRANSFER KIT. 9. Press to select NEW TRANSFER KIT. 10. Press to highlight YES. 11. Press to select YES. The transfer unit count is reset and the printer is ready to use. Replacing the fuser and pickup roller Replace the fuser and pickup roller when the printer control panel displays the message REPLACE FUSER KIT. The image fuser kit contains a replacement fuser and a Tray 2 pickup roller for this printer. After replacing the fuser, you must also replace the pickup roller. Instructions for replacing the pickup roller follow the instructions for replacing the fuser. ENWW Replacing supplies and parts 119