HP A7533A HP StorageWorks Fabric OS 6.1.1 administrator guide (5697-0235, Dece - Page 123

The output displays the WWN, Domain ID, and name (if known) of the switches with defined shared secrets: WWN DId Name 10:00:00:60:69:80:07:52 Unknown 10:00:00:60:69:80:07:5c 1 switchA To set a secret key pair: 1. Log in to the switch using an account assigned to the admin role. 2. On a switch running Fabric OS 4.x, 5.x, or 6.0.0 or later, enter secAuthSecret --set. On a switch running Fabric OS 3.x, enter secAuthSecret "--set". The command enters interactive mode. The command returns a description of itself and needed input; then it loops through a sequence of switch specification, peer secret entry, and local secret entry. To exit the loop, press Enter for the switch name; then enter y. switchA:admin> secauthsecret --set This command is used to set up secret keys for the DH-CHAP authentication. The minimum length of a secret key is 8 characters and maximum 40 characters. Setting up secret keys does not initiate DH-CHAP authentication. If switch is configured to do DH-CHAP, it is performed whenever a port or a switch is enabled. Warning: Please use a secure channel for setting secrets. Using an insecure channel is not safe and may compromise secrets. Following inputs should be specified for each entry. 1. WWN for which secret is being set up. 2. Peer secret: The secret of the peer that authenticates to peer. 3. Local secret: The local secret that authenticates peer. Press Enter to start setting up shared secrets > Enter WWN, Domain, or switch name (Leave blank when done): 10:20:30:40:50:60:70:80 Enter peer secret: Re-enter peer secret: Enter local secret: Re-enter local secret: Enter WWN, Domain, or switch name (Leave blank when done): 10:20:30:40:50:60:70:81 Enter peer secret: Re-enter peer secret: Enter local secret: Re-enter local secret: Enter WWN, Domain, or switch name (Leave blank when done): Are you done? (yes, y, no, n): [no] y Saving data to key store... Done. 3. Disable and enable the ports on a peer switch using the portDisable and portEnable commands. Fabric OS 6.1.1 administrator guide 123