HP A7533A HP StorageWorks Fabric OS 6.1.1 administrator guide (5697-0235, Dece - Page 318

1. Log in to the switch or director as admin and issue the version command. Verify that Fabric OS 6.1 is installed on the FC router as shown in the following example. switch:admin> version Kernel: 2.6.14.2 Fabric OS: v6.1.0 Made on: Wed Mar 12 01:15:34 2008 Flash: Fri Mar 14 20:53:48 2008 BootProm: 4.6.6 2. Perform the following appropriate action based on the hardware model you are configuring: • If you are configuring the 4/256 SAN Director, issue the slotShow command to verify that the FR4-18i blade is present. • If you are configuring the DC Director, issue the slotShow command to verify that either the FR4-18i blade is present or, if configuring EX_Ports on an 8-Gbps port blade, that the FC8-16, FC8-32, or FC8-48 blade is present. The following example shows slot 2 with the FR4-18i blade and slots 3, 9, 10, and 12 with 8-Gbps port blades enabled. • If you are not configuring a 4/256 SAN Director or DC Director platform, skip to step 5. switch:admin> slotshow -m Slot Blade Type ID Model Name Status 1 AP BLADE 33 FA4-18 ENABLED 2 AP BLADE 24 FR4-18i ENABLED 3 SW BLADE 37 FC8-16 ENABLED 4 SW BLADE 39 FC10-6 ENABLED 5 CORE BLADE 52 CORE8 ENABLED 6 CP BLADE 50 CP8 ENABLED 7 CP BLADE 50 CP8 ENABLED 8 CORE BLADE 52 CORE8 ENABLED 9 SW BLADE 37 FC8-16 ENABLED 10 SW BLADE 55 FC8-32 ENABLED 11 UNKNOWN VACANT 12 SW BLADE 51 FC8-48 ENABLED See "Configuring Directors" on page 225 for a list of blades and their corresponding IDs. 3. If you are configuring EX_Ports on the 8-Gbps port blades on the DC Director (FC8-16, FC8-32, or FC8-48), issue the licenseShow command to verify that the Integrated Routing license is installed: switch:admin> licenseshow S9bddb9SQbTAceeC: Fabric license bzbzRcbcSc0c0SY: Remote Fabric license RyeSzRScycazfT0G: Integrated Routing license If the Integrated Routing license is not installed, you must install it, as described in "Licensed features" on page 34. 4. If you are configuring the 4/256 SAN Director with an FR4-18i blade, issue the chassisConfig command to verify that the director is using configuration option 5. switch:admin> chassisconfig Current Option: 5 All Supported Options Option 5: One 384-port switch Blade ID's 17, 18, 24, 31, 36, 39, 37, 51, 55 in slots 1-4, 7-10 Blade ID 16 in slots 5-6 318 Using the FC-FC routing service