HP A7533A HP StorageWorks Fabric OS 6.1.1 administrator guide (5697-0235, Dece - Page 45
Disabling and enabling ports, Making basic connections
UPC - 829160830858
View all HP A7533A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Disabling and enabling ports By default, all licensed ports are enabled. You can disable and reenable them as necessary. Ports that you activate with Ports on Demand must be enabled explicitly, as described in "Activating POD" on page 40. WARNING! The fabric will be reconfigured if the port you are enabling or disabling is connected to another switch. The switch whose port has been disabled will be segmented from the fabric and all traffic flowing between it and the fabric will be lost. To disable a port: 1. Connect to the switch and log in using an account assigned to the admin role. 2. Issue the following command: switch:admin> portdisable portnumber where portnumber is the port number of the port you want to disable. For 4/256 SAN Director and DC SAN Backbone Director (short name, DC Director): Issue the following command: switch:admin> portdisable slotnumber/portnumber where slotnumber and portnumber are the slot and port numbers of the port you want to disable. To enable a port: 1. Connect to the switch and log in using an admin account. 2. Issue the following command: switch:admin> portenable portnumber where portnumber is the port number of the port you want to enable. For 4/256 SAN Director and DC Director: Issue the following command: switch:admin> portenable slotnumber/portnumber where slotnumber and portnumber are the slot and port numbers of the port you want to enable. (Slots are numbered 1 through 4 and 7 through 10, counting from left to right.) If the port is connected to another switch, the fabric may be reconfigured. If the port is connected to one or more devices, these devices become available to the fabric. If you change port configurations during a switch failover, the ports may become disabled. To bring the ports online, re-issue the portEnable command after the failover is complete. Making basic connections You can make basic connections to devices and to other switches. Before connecting a switch to a fabric that contains switches running different firmware versions, you must first set the same PID format on all switches. The presence of different PID formats in a fabric causes fabric segmentation. • For information on PID formats and related procedures, see "Selecting a PID format" on page 453. • For information on configuring the routing of connections, see "Routing traffic" on page 237. 3. For information on configuring extended interswitch connections, see "Administering extended fabrics" on page 359. Connecting to devices To minimize port logins, power off all devices before connecting them to the switch. For devices that cannot be powered off, first use the portDisable command to disable the port on the switch, and then connect Fabric OS 6.1.1 administrator guide 45