HP A7533A HP StorageWorks Fabric OS 6.1.1 administrator guide (5697-0235, Dece - Page 295
TI within an edge fabric
![]() |
UPC - 829160830858
View all HP A7533A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 295 highlights
Edge fabric 1 Backbone fabric Edge fabric 2 = Dedicated path set up by TI zone in edge fabric 1 = Dedicated path set up by TI zone in edge fabric 2 = Dedicated path set up by TI zone in backbone fabric Figure 30 Traffic isolation over FCR In addition to setting up TI zones, you must also ensure that the devices are in an LSAN zone, so that they may communicate with each other. If failover is enabled and the TI path is not available, an alternate plan is used. If failover is disabled and the TI path is not available, devices are not imported. NOTE: For TI over FCR, all switches in the backbone fabric and the edge fabrics must be running Fabric OS 6.1.0 or later. TI within an edge fabric A TI zone within an edge fabric is used to route traffic between a real device and a proxy device through a particular EX_Port. For example, in Figure 31, you can set up a TI zone to ensure that traffic between Host 1 and the proxy target is routed through EX_Port 9. Host 1 Domain 1 8 1 9 2 Front Domain 3 9 10 -1 Host 2 E_Ports EX_Ports -1 = Dedicated Path = Ports in the TI zone Xlate Domain 4 Proxy Target Figure 31 TI zone in an edge fabric In the TI zone, when you designate E_Ports between the front and xlate phantom switches, you must use -1 in place of the I in the D,I notation. Both the front and xlate domains must be included in the TI zone. Fabric OS 6.1.x administrator guide 295
![](/manual_guide/products/hewlettpackard-ae370a-hp-storageworks-fabric-os-611-administrator-guide-56970235-2009-a28315e/295.png)