HP A7533A HP StorageWorks Fabric OS 6.1.1 administrator guide (5697-0235, Dece - Page 404
is the number of ping requests to make. The default is 4.
UPC - 829160830858
View all HP A7533A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 404 highlights
The following example verifies that the two routes have been successfully created: switch:admin06> portshow iproute 8/ge0 Slot: 8 Port: ge0 IP Address Mask Gateway Metric Flags 192.168.100.0 255.255.255.0 192.168.100.40 0 Interface 192.168.100.0 255.255.255.0 192.168.100.41 0 Interface 192.168.11.0 255.255.255.0 192.168.100.1 1 192.168.12.0 255.255.255.0 192.168.100.1 1 3. If you are implementing VLAN tagging, create a static ARP entry for the IP interfaces on both ends of the tunnel using the portcfg arp command with the add option: portcfg arp [slot/]ge0|ge1 add ipaddr macaddr You can obtain the MAC address (macaddr) by using the portshow arp command with the -lmac option. 4. Verify IP connectivity by issuing the portCmd --ping command to test the connection to a destination IP address from a source IP address on one of the local Ethernet ports (Ge0 or Ge1). This verification also ensures that data packets can be sent to the remote interface. You can test a connection only if both ports have IP interfaces set. The command syntax is as follows: portcmd --ping [slot/]ge0|ge1 [-s source_ip] [-d dest_ip] [-c L2 class-of-service] [-n num-requests] [-q type-of-service] [-t ttl] [-v vlan tag] [-w wait-time] [-z size] where: slot is the number of a slot in a 4/256 SAN Director or DC Director chassis that contains an FR4-18i blade. This parameter does not apply to the stand-alone 400 Multi-protocol Router ge0|ge1 is the Ethernet port used by the tunnel (ge0 or ge1). -s source_ip is the source IP interface that originates the ping request. -d destination_ip is the destination IP address for the ping request. -c class-of-service is the Layer 2 class of service (L2CoS). -n num-requests is the number of ping requests to make. The default is 4. -q type-of-service is the DiffServ QoS. The default is 0 (zero). The value must be an integer in the range 0 to 255. -t ttl is the time to live. The default value is 100. -v vlan tag is the vlan tag for a VLAN tagged IP connection. -w wait-time is the time to wait for the response of each ping request. This parameter is specified in milliseconds and the default value is 5000 (5 seconds). The maximum allowed wait time for ping is 29000 milliseconds (9 seconds). -z size The size in bytes of the ping packet to use. The total size cannot be greater than the configured MTU size (see step 1). The default size is 64 bytes. 404 Configuring and monitoring FCIP extension services