HP A7533A HP StorageWorks Fabric OS 6.1.1 administrator guide (5697-0235, Dece - Page 418
FCIP tunnel performance characteristics
UPC - 829160830858
View all HP A7533A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 418 highlights
-h max_hops -f first_ttl -q diffserv -w wait-time -z size -v vlan_id -c L2_Cos The maximum number of IP router hops allowed for the outbound probe packets. If this value is exceeded, the probe is stopped. The default is 30. The initial time to live value for the first outbound probe packet. The default value is 1. The DiffServ QoS. The default is 0 (zero). The value must be an integer in the range from 0 through 255. The time to wait for the response of each ping request. This parameter is specified in milliseconds and the default value is 5000 milliseconds (5 seconds). The maximum allowed wait time for ping is 9000 milliseconds (9 seconds). The size in bytes of the ping packet to use. The total size cannot be greater than the configured MTU size. You can use the portshow ipif command to display the MTU size for ge0 or ge1. The default size is 64 bytes. Specifies the VLAN ID. Values must be in the range 1 - 4094. There is no default value. Note that a VLAN tag entry must exist on the local and remote sides prior to issuing the -v option. A VLAN Tag table entry will be dynamically maintained by the ipperf application. See the portCfg help page for details on creating a VLAN tag table. Specifies Class of Service/Priority, as defined by IEEE 802.1p. Values must be in the range between 0 and 7. The default is 0. This operand is optional with the -v option. The following example traces the route between IP addresses 192.168.10.1 and 192.168.20.1 over VLAN 10. portcmd --traceroute 8/ge0 -s 192.168.10.1 -d 192.168.20.1 -v 10 FCIP tunnel performance characteristics You can use the portShow fcipTunnel command to view the performance statistics and monitor the behavior of an online FCIP tunnel. To view detailed fcipTunnel statistics, you must specify either the -perf or -params options. The command syntax is as follows: switch:admin06> portshow fciptunnel [Slot]/ge0|ge1 -perf -params 418 Configuring and monitoring FCIP extension services