HP A7533A HP StorageWorks Fabric OS 6.1.1 administrator guide (5697-0235, Dece - Page 308
QoS on E_Ports, Supported configurations for traffic prioritization
![]() |
UPC - 829160830858
View all HP A7533A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 308 highlights
QoS on E_Ports In addition to configuring the hosts and targets in a zone, you must also enable QoS on individual E_Ports that might carry traffic between the given host and target pairs. Path selection between the host,target pairs is governed by FSPF rules and is not affected by QoS priorities. By default, QoS is enabled on E_Ports in port configuration. For example, in Figure 36, QoS should be enabled on the encircled E_Ports. H1 Domain 1 Domain 3 S1 1 9 H2 14 3 13 12 S2 15 87 = Low priority 16 S3 = Medium priority = High priority = E_Ports with QoS enabled Domain 2 Figure 36 QoS with E_Ports enabled Domain 4 You must enable QoS on the E_Ports on both ISLs between Domain 3 and Domain 4 because either path might be selected to carry the traffic. You do not need to enable QoS on the E_Ports on the ISLs between Domain 1 and Domain 2 and between Domain 2 and Domain 3, because these are not the shortest paths between the hosts and the targets. However, if the ISL between Domain 1 and Domain 3 is broken, the path through Domain 2 would be used. To guarantee traffic priority, enable QoS on all possible E_Ports. Alternatively, you could use a TI zone to limit the E_Ports that carry the traffic between a host,target pair and enable QoS on only those E_Ports. If QoS is not enabled on an E_Port, the traffic prioritization stops at that point. For example, in Figure 36 if you disabled QoS on E_Ports 3,12 and 3,13 then the traffic from H1 and H2 to S3 would be low priority from the hosts to Domain 3, but would switch to the default (medium) priority from Domain 3 to the target S3. Supported configurations for traffic prioritization Note the following configuration rules for traffic prioritization: IMPORTANT: All switches in the fabric must be running Fabric OS 6.0.0b or later. If QoS traffic crosses an ISL for a switch running a firmware version earlier than 6.0.0, the frames are dropped. • By default, all devices are assigned medium priority. To be assigned high or low priority, hosts and targets must be connected to: • 8/8 SAN Switch or 8/24 SAN Switch • 8/40 SAN Switch • 8/80 SAN Switch • FC8-16, FC8-32, or FC8-48 port blade in the DC director • To preserve the priority level across ISLs, the switches must be running Fabric OS 6.0.0b or later and must be one of the following: 8/8 SAN Switch, 8/24 SAN Switch, 8/40 SAN Switch, 8/80 SAN Switch, 4/32 SAN Switch, 4/32B SAN Swich, 4/64 SAN Switch, 400 Multi-protocol router, 4/256 SAN Director, or DC Director. 308 Optimizing fabric behavior
![](/manual_guide/products/hewlettpackard-ae370a-hp-storageworks-fabric-os-611-administrator-guide-56970235-2009-a28315e/308.png)