HP A7533A HP StorageWorks Fabric OS 6.1.1 administrator guide (5697-0235, Dece - Page 303

Host 1 Target 1 Target 2 Domain ID = 1 8 5 Edge fabric 1 Domain ID = 4 9 1 4 Backbone fabric Domain ID = 2 23 6 7 Domain ID = 9 Edge fabric 2 = Dedicated path set up by TI zone in edge fabric 1 = Dedicated path set up by TI zone in edge fabric 2 = Dedicated path set up by TI zone in backbone fabric Figure 34 TI over FCR example In the following procedure the three TI zones in the edge and backbone fabrics are all given the same name, TI_Zone1. It is not required that the TI zones have the same name, but this is done to avoid confusion. If several dedicated paths are set up across the FC router, the TI zones for each path can have the same name. 1. In each edge fabric, set up an LSAN zone that includes Host 1, Target 1, and Target 2, so these devices can communicate with each other. See "Optimizing fabric behavior" on page 291 for information about creating LSAN zones. 2. Log in to the edge fabric 1 and set up the TI zone. a. Issue the fabricShow command to display the switches in the fabric. From the output, you can determine the front and translate domains. E1switch:admin> fabricshow Switch ID Worldwide Name Enet IP Addr FC IP Addr Name 1: fffc01 50:00:51:e3:95:36:7e:04 0.0.0.0 0.0.0.0 "fcr_fd_1" 4: fffc04 10:00:00:60:69:80:1d:bc 10.32.72.4 0.0.0.0 >"E1switch" 6: fffc06 50:00:51:e3:95:48:9f:a0 0.0.0.0 0.0.0.0 "fcr_xd_6_9" The Fabric has 3 switches b. Issue the following commands to create and display a TI zone: E1switch:admin> zone --create -t ti TI_Zone1 -p "4,8; 4,5, 1,-1; 6,-1" E1switch:admin> zone --show Defined TI zone configuration: TI Zone Name: TI_Zone1 Port List: 4,8; 4,5; 1,-1; 6,-1 Status: Activated Failover: Enabled Fabric OS 6.1.x administrator guide 303