HP A7533A HP StorageWorks Fabric OS 6.1.1 administrator guide (5697-0235, Dece - Page 407
Fastwrite on, Tape Pipelining
![]() |
UPC - 829160830858
View all HP A7533A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 407 highlights
The following example shows an active tunnel with FCIP fastwrite and tape pipelining enabled: switch:admin06> portshow fciptunnel ge0 all Tunnel ID 1 Remote IP Addr 192.168.1.2 Local IP Addr 192.168.1.201 Remote WWN Not Configured Local WWN 10:00:00:05:1e:35:1f:ed Compression off Fastwrite on Tape Pipelining on Uncommitted bandwidth, minimum of 1000 Kbps (0.001000 Gbps) SACK on Min Retransmit Time 100 Keepalive Timeout 10 Max Retransmissions 8 Connected Count: 0 Status : Active Uptime 21 seconds If IPSec has been enabled and a policy added to the configuration, you will see the policy information under the status section of the output, as shown below. The policy information is visible only when IPSec is configured and is displayed with the information shown in the example above when the portShow command is issued. IKE Policy 1 Authentication Algorithm: SHA-1 Encryption: 3DES Perfect Forward Security: off Diffie-Hellman Group: 1 SA Life (seconds): 3600 SA Life (MB): 4500 IPSec Policy 1 Authentication Algorithm: SHA-1 Encryption: 3DES Perfect Forward Security: off Diffie-Hellman Group: 1 SA Life (seconds): 3600 SA Life (MB): 4500 Pre-Shared Key 0x1234500000000000000000000000000000 After FCIP tunnels are created, the configuration is saved in a persistent database. At this point, all configured FCIP tunnels now appear in the fabric as VE_Ports. Fabric OS 6.1.x administrator guide 407
![](/manual_guide/products/hewlettpackard-ae370a-hp-storageworks-fabric-os-611-administrator-guide-56970235-2009-a28315e/407.png)