HP Designjet 10000s HP Designjet 10000s Printer series - User's Guide - Page 129
Dual media rolls take-up method 2
View all HP Designjet 10000s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
13. Mount the tension bar (1), in the slack area of the media, and adjust the take-up flanges to the width of the media. CAUTION Make sure you install the tension bar with the ESD flange at the left hand end of the tension bar (viewed from the rear of the printer). How do I use dual media rolls? 14. At the rear of the printer, set the white media winding direction switch (1) to the correct position for the direction the media is to be taken-up, inner take-up (A) or outer take-up (B). Dual media rolls take-up method 2 This procedure describes how to take-up two tarpaulin media rolls onto two separate media tubes. NOTE Use media tubes with as closely matching internal diameters as possible because a small difference in diameter greatly affects the take-up length of the media rolls causing abnormal operation. ENWW Use the take-up reel (dual media rolls) 119