HP Designjet 10000s HP Designjet 10000s Printer series - User's Guide - Page 23
Connect to a computer
View all HP Designjet 10000s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Introduction 4. To exit the parameter setup mode, scroll to the EXIT option and press the On/Off key to select YES. 5. Press the On/Off key on the heater front panel to confirm. Connect to a computer This section describes system configuration and cable connection procedures. NOTE Before connecting or disconnecting the USB cable, turn the printer OFF. Choose the system configuration The following connections are possible. 1. Printer 2. USB interface 3. Printer server (RIP) Connection procedure CAUTION Make sure the USB cable is correctly routed to avoid contact with the media. NOTE Before you connect the USB cable, you should ensure that the RIP is installed so that the printer can be detected by your operating system. Refer to the instructions that came with your RIP for installation instructions. ENWW Connect to a computer 13