HP Designjet 10000s HP Designjet 10000s Printer series - User's Guide - Page 22

The printer's heaters

This section describes how to control the printer's heaters used for drying the printed media.

The heater's front panel

The heater's front panel is located on the front of the printer, on the left-hand side. The heater front panel

displays the settings for the Front, Print, and Rear heaters. It can also be used to control the temperature

settings.

1.

The display screen, at the top of the panel, shows the target temperature and the current temperature

of each heater.

2.

The three

On/Off

switches turn the three heaters on or off. The three pairs of

or

keys can be used

to raise or lower the target temperatures of the respective heaters.

Defining heater parameters

1.

On the heater front panel press the

On/Off

key, and the

and

keys at the same time to enter the

parameter setup mode.

2.

Select a setup parameter using the

and

keys on the heater front panel and press the

On/Off

key

on the heater front panel to modify the setup item displayed.

3.

Use the

and

keys to select the value and press the

On/Off

key to confirm.

NOTE

If you have selected an incorrect setup value, you can press the

On/Off

key again

to cancel the setting and repeat from step 2.

12

Chapter 1

Introduction

ENWW

Introduction

HP Designjet 10000s HP Designjet 10000s Printer series - User's Guide - Page 22

The printer's heaters

Page 22 highlights