HP Designjet 10000s HP Designjet 10000s Printer series - User's Guide - Page 313

Heater preset temperature by medium The heater preset temperature for each media type is listed below. Preset the heater temperature according to the media you use. Medium Glossy vinyl chloride Matte vinyl chloride Banner Media type Glossy Matte Banner Front 45°C 45°C 45°C Print 40°C 40°C 40°C Rear 45°C 45°C 45°C Print mode 4-pass bidirectional 4-pass bidirectional 4-pass bidirectional We recommend that the front heater, the print heater and the rear heater be set to lower than 50 °C, 45 ° C and 50 °C, respectively. When the print heater is set to higher than 45 °C, we recommend setting the printhead motion mode to HIGHLIGHT. NOTE When the print heater temperature is set too high, fixing of the ink on the media is improved, but media wrinkle or mat print may be caused. Adjust heater temperature according to the media type and environmental temperature. When the print heater temperature is set to high, the printer may print at low speed to ensure stable print quality. Set the front/rear heater temperature 5 °C higher than the print heater temperature. Bad temperature balance between the front/rear heater and print heater may cause the media to wrinkle. Tell me about the heaters ENWW Heater temperature settings 303