HP Designjet 10000s HP Designjet 10000s Printer series - User's Guide - Page 51

How do I perform basic media operations? 19. Verify the front panel shows this message and press the OK key. NOTE The next operation will not start if the media is too tight. The media setting operation starts automatically and shows this message on the front panel. If the operation completes correctly, the printer returns to the online or offline state. If it does not complete correctly, the front panel will show an error message. If this occurs, retry the operation from the step in this procedure where you raised the media load lever. NOTE The temperature at each end of the platen is slightly lower than the temperature at the central area. On rare occasions, this temperature difference could cause color density irregularities at the edges when the media is slow to dry. This color difference is most apparent when using vinyl chloride (PVC) media. If raising the temperature (Refer to Heater temperature settings) does not remove the color density irregularity at the edges this can be solved by using the offset media loading option (Refer to Offset media loading using the main scroller). This option moves the media out of the affected area but this option is only available when using vinyl chloride (PVC) media, on a single roll, with a width of less than 2,000 mm installed on the main scroller. ENWW Install a media roll in the printer using the main scroller 41