HP Deskjet F2100 User Guide - Page 122

Cannot load paper from input tray, Ink is drying, Out of paper, Paper jam, misfeed or blocked carriage

Get HP Deskjet F2100 - All-in-One Printer PDF manuals and user guides View all HP Deskjet F2100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 122 highlights

Troubleshooting Chapter 12 • Paper jam, misfeed or blocked carriage • Paper mismatch • Wrong paper width Cannot load paper from input tray Cause: There is not enough paper in the input tray. Solution: If the HP All-in-One is out of paper or there are only a few sheets remaining, load more paper in the input tray. If there is paper in the input tray, remove the paper, tap the stack of paper against a flat surface, and reload the paper into the input tray. To continue your print job, press the Resume button, which is located next to the Check Paper and Check Print Cartridge lights on the control panel of the HP Allin-One. Ink is drying Cause: Transparencies and some other media require a drying time that is longer than normal. Solution: Leave the sheet in the output tray until the message disappears. If it is necessary to remove the printed sheet before the message disappears, carefully hold the printed sheet on the underside or the edges, and place it on a flat surface to dry. Out of paper Cause: There is not enough paper in the input tray. Solution: If the HP All-in-One is out of paper or there are only a few sheets remaining, load more paper in the input tray. If there is paper in the input tray, remove the paper, tap the stack of paper against a flat surface, and reload the paper into the input tray. To continue your print job, press the Resume button, which is located next to the Check Paper and Check Print Cartridge lights on the control panel of the HP Allin-One. Cause: The rear door is off the HP All-in-One. Solution: If you removed the rear door to clear a paper jam, replace it. For more information, see: Clear paper jams Paper jam, misfeed or blocked carriage Cause: The HP All-in-One has a paper jam. Solution: Clear the paper jam. For more information, see: Clear paper jams 120 Troubleshooting

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
•
Paper jam, misfeed or blocked carriage
•
Paper mismatch
•
Wrong paper width
Cannot load paper from input tray
Cause:
There is not enough paper in the input tray.
Solution:
If the HP All-in-One is out of paper or there are only a few sheets
remaining, load more paper in the input tray. If there is paper in the input tray, remove
the paper, tap the stack of paper against a flat surface, and reload the paper into the
input tray. To continue your print job, press the Resume button, which is located next
to the Check Paper and Check Print Cartridge lights on the control panel of the HP All-
in-One.
Ink is drying
Cause:
Transparencies and some other media require a drying time that is longer
than normal.
Solution:
Leave the sheet in the output tray until the message disappears. If it is
necessary to remove the printed sheet before the message disappears, carefully hold
the printed sheet on the underside or the edges, and place it on a flat surface to dry.
Out of paper
Cause:
There is not enough paper in the input tray.
Solution:
If the HP All-in-One is out of paper or there are only a few sheets
remaining, load more paper in the input tray. If there is paper in the input tray, remove
the paper, tap the stack of paper against a flat surface, and reload the paper into the
input tray. To continue your print job, press the Resume button, which is located next
to the Check Paper and Check Print Cartridge lights on the control panel of the HP All-
in-One.
Cause:
The rear door is off the HP All-in-One.
Solution:
If you removed the rear door to clear a paper jam, replace it.
For more information, see:
Clear paper jams
Paper jam, misfeed or blocked carriage
Cause:
The HP All-in-One has a paper jam.
Solution:
Clear the paper jam.
For more information, see:
Clear paper jams
Chapter 12
120
Troubleshooting
Troubleshooting