HP LH4r HP Netserver LH 6000 Installation Guide - Page 119

Chapter 10 Configuring the HP NetServer ◊ Select View Hardware Inventory on the Show System Information screen to display information about standard and accessory boards and devices in the system. ◊ Select View Resources on the Show System Information screen to display used and available system resources such as memory ranges, I/O port ranges, DMA channels, and interrupt (IRQ) levels. • Configure Disk Array: This configures your HP disk array. Refer to the Integrated HP NetRAID Controller Configuration Guide. NOTE When you configure an array, the default cache mode is write-through. For write-back mode, install the optional battery back-up accessory. • Install Utility Partition: This step creates an 32 MB DOS-based utility partition on the NetServer hard disk where HP Navigator will copy DiagTools, the BIOS Update utility, the Event Log Report utility, the Disk Array utility, the NIC Configuration utility, the Integrated Remote Assistant utilities, troubleshooting utilities, and other utilities. A Utility Partition is not available for SCO UnixWare. Select Execute on the Install Utility Partition screen. • Execute Card Utilities: Use this function, when Configuration Assistant detects installed boards, which have additional configuration utilities on the HP NetServer Navigator CD-ROM. By selecting Execute on the Execute Board Utilities screen, you can execute these utilities to complete the configuration of the boards. 111