HP LH4r HP Netserver LH 6000 Installation Guide - Page 65
Slot 3A and Slot 3B
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Chapter 5 Installing Additional Memory Figure 5-4. System Board Assembly on Grounded Anti-static pad 9. Identify the slot locations for the DIMM pair(s) being added: Table 5-1. Paired Memory Slots Slot 1A and Slot 1B Slot 2A and Slot 2B Slot 3A and Slot 3B Slot 4A and Slot 4B 10. Install the DIMM pairs: a. Spread the latches outward on each slot receiving a DIMM. b. Remove a DIMM from its anti-static bag, handling the module by its edges. c. Align the notches on the DIMM with the slot keys on the slot (see Figure 5-5). d. Press the DIMM into the slot until the latches close. CAUTION Do not rock the DIMM into place, but apply firm and even pressure. If a gap exists between the retaining latches and the DIMM, remove and replace the module until no gap exists. 57