HP LH4r HP Netserver LH 6000 Installation Guide - Page 77
Remove the hot-plug board., Either replace the hot-plug board or reinstall the slot cover., Close
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
Chapter 6 Installing Additional Boards Note: Ejector only moves 10 mm (3/8 inch) Figure 6-6. Removing a Hot Plug Board 4. Remove the hot-plug board. 5. Either replace the hot-plug board or reinstall the slot cover. 6. Close the PCI hold-down latch. 69
Chapter 6
Installing Additional Boards
69
Note: Ejector only
moves 10 mm (3/8 inch)
Figure 6-6. Removing a Hot Plug Board
4.
Remove the hot-plug board.
5.
Either replace the hot-plug board or reinstall the slot cover.
6.
Close the PCI hold-down latch.