HP LH4r HP Netserver LH 6000 Installation Guide - Page 132
Changing Internal Device Boot Priority
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 132 highlights
Chapter 10 Configuring the HP NetServer Changing Internal Device Boot Priority You can change the boot priority of the HP NetServer's internal mass storage devices: the CD-ROM, the flexible disk drive (or other removable device), and hard drives connected to the HP NetServer's internal SCSI ports. To do this: 1. Select "Boot Settings" from the Configuration menu, using the down-arrow or up-arrow key, and press Enter. A Boot Settings screen appears, very similar to the following one. Floppy check: [Disabled] Summary screen: [Enabled] Quick Boot mode: [Enabled] Boot Device Priority Hard Drive Priority 2. Use the down-arrow key to move to the "Boot Device Priority" field. 3. Press Enter to change the order and a list appears very similar to the one below: 1. [CD-ROM] 2. [Flexible Disk] 3. [Hard Drive] 4. [Network Boot] The list provides the current boot order of the internal devices, including a NIC connected to a network. If the [Hard Drive] selection is moved to the top of the boot list, the hard drive selected in Steps 5-7 is used to boot the system. a. To change the order, use the up- and down-arrow keys to select one of the devices. b. Use the plus (+) or minus (-) keys to move a device up or down the list. 4. Press Esc to exit one level to the Boot Settings menu. This moves you back one level to the Boot Settings list shown in Step 1 above. 5. To change the hard drive boot order, scroll to "Hard Drive Priority" and press Enter. 124