HP LH4r HP Netserver LH 6000 Installation Guide - Page 67
Installing Additional Boards
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
6 Installing Additional Boards Introduction This chapter describes how to install accessory boards into the I/O board. The I/O board is located under the top cover of the LH 6000r and under the left cover of the LH 6000. Refer to Chapter 3, "Opening and Closing the HP NetServer," for instructions on removing the covers. Remote Management I/O Memory SE SCSI Slots 1- 4 Non- hot-plug Slots 1- 6 +5V 33 MHz/64 Bit Slots 5- 8 Hot-plug Slots 7 and 8 +3.3V or +5V 66 MHz/64 Bit SCSI A SCSI B Power LEDs Attention LEDs Figure 6-1. I/O Board The I/O board provides eight slots. All eight slots support standard PCI boards and slots 5, 6, 7, and 8 support PCI boards with the Hot Plug option. The I/O board comprises: • Eight PCI Board slots l The PCI Hot-Plug LEDs • The two Ultra-2 SCSI connectors, A and B 59