HP LH4r HP Netserver LH 6000 Installation Guide - Page 61
Installing Additional Memory
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
5 Installing Additional Memory Introduction This chapter describes how to add memory to the HP NetServer LH 6000r or the HP NetServer LH 6000. The standard configuration ships with 256 MB of interleaved memory, one 128 MB DIMM in slot 1A and one 128 MB DIMM in slot 1B. Expansion is accomplished by adding pairs of equal size DIMMs in stipulated slots up to the maximum configuration of 8 GB. *1 1A *2 2A *3 3A *4 4A DIMM Slots *5 1B *6 2B *7 3B *8 4B S1 *=Event Log DIMM numbers Figure 5-1. DIMM slots on System Board Memory Guidelines l Add paired DIMMs of these sizes: ◊ 128 MB ◊ 256 MB ◊ 512 MB ◊ 1 GB l Memory of equal size must be added in pairs. l You can mix DIMM sizes. For example, you may place a 1 GB DIMM pair next to a 128 MB DIMM pair. l Add memory in pairs and in any order to the three remaining slot pairs. l Maximum configuration is 8 GB. l Do not rock the DIMM into place, but apply firm and even pressure until it is seated in the slot. l Use only HP-supported DIMMs. 53