HP Media Center m1200 Getting Started Guide - Page 21

Connecting the Remote Sensor

Get HP Media Center m1200 - Desktop PC PDF manuals and user guides View all HP Media Center m1200 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

Connecting the Remote Sensor The remote sensor is a small device that connects to the PC and allows the remote control to work with the Media Center program. 1 If you have a cable TV set-top box, a satellite set-top box, or other set-top box that controls your TV signal, connect the remote control sensor cable (emitter) (A) into the back of the remote sensor. 2 Remove the paper from the backing tape on the end of the cable (B) and then press the end of the cable over the remote IR receiver window on your cable TV set-top box (C). 3 Plug the remote control sensor cable into a USB connector (D) on the back of the PC. 4 Place the remote sensor so that you can easily point at it with the remote control. (An ideal spot would be on top of the monitor or desk.) P C A B D Setting Up the PC 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
Setting Up the PC
17
Connecting the Remote Sensor
The remote sensor is a small device that connects to
the PC and allows the remote control to work with
the Media Center program.
1
If you have a cable TV set-top box, a satellite
set-top box, or other set-top box that controls
your TV signal, connect the remote control
sensor cable (emitter) (
A
) into the back of the
remote sensor.
2
Remove the paper from the backing tape on
the end of the cable (
B
) and then press the
end of the cable over the remote IR receiver
window on your cable TV set-top box (
C
).
3
Plug the remote control sensor cable into a
USB connector (
D
) on the back of the PC.
4
Place the remote sensor so that you can easily
point at it with the remote control. (An ideal
spot would be on top of the monitor or desk.)
P
B
A
C
D