HP Media Center m1200 Getting Started Guide - Page 28
Connecting the TV Signal Source
View all HP Media Center m1200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
n Location and number of connectors may vary by model. Connecting the TV Signal Source Connect the signal source for the TV by using the TV In coaxial connector or the S-video In connector. Plug the connector of a coaxial cable from your TV antenna or from your TV cable (wall or set-top box) into the TV/RF-In (D) connector on the back of the PC, and then turn the connector to tighten it. Or Plug a cable into the S-video In (C) connector on the back of the PC; use an S-video cable (not provided) or use the S-video to composite video adapter cable and the composite video cable. Plug the other end of the cable into your set-top box or other device that is providing the signal source for the TV. You must also plug audio cables (not provided) from your set-top box into the Audio In right (red) (A) connector and the Audio In left (white) (B) connector on the back of the PC, if you are using a set-top box with S-video or composite video output. FM IN TV IN S-VID IN L R AB C D 24 HP Media Center PC Getting Started Guide