HP Workstation x4000 hp workstation x4000 - Technical Reference manual - Windo - Page 183
Installing the Floppy Disk Drive, Floppy Disk Drive,
View all HP Workstation x4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 183 highlights
Installing or Replacing Parts and Accessories Floppy Disk Drive Installing the Floppy Disk Drive 1. Add the guide rails to the new drive. Insert the guide rail labeled "L" on the left-hand side (cable connectors facing towards you and positioned at the top), and the guide rail "R" on the right-hand side of the floppy disk drive. 2. Align the guide rails on both sides of the drive with the internal shelf guides, then slide the drive until it clicks into position. 3. Connect the power and floppy data cables to the new drive. The connectors are shaped to go in one way only. 4. Replace the front bezel and Workstation's cover (refer to "Replacing the Cover and Front Bezel" on page 148). 5. Reconnect all the power and telecommunications cables. Chapter 10 181