Hitachi DZ-HS903A Owners Guide - Page 166
Quick Start
UPC - 050585224117
View all Hitachi DZ-HS903A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 166 highlights
Symptom Cause and Correction Reference page The remote control Do you operate the remote control toward the remote does not operate. control receiver of the camcorder? 16 If the camcorder's remote control receiver is exposed to strong light such as direct sunshine or fluorescent light, the remote control does not work. - Adjust the position or angle of the camcorder. Is the lithium battery inserted in the remote control? Check that the polarization of the lithium battery is correctly set. 17 The lithium battery may be empty. Replace the battery to a new one. Is the camcorder powered on? If not, turn on the camcorder. 22 Disc compartment Is the disc correctly inserted? lid cannot be closed. Remove the disc and then reinsert it. 34 Connect a fully charged battery or AC adapter/charger, and then turn the camcorder on and try again. 21, 38 Operating noise is This is not a fault. A quiet operating sound is heard as the heard. disc rotates during recording or playback, etc. - Some vibrations are These vibrations or sound are caused by HDD/DVD felt or slight sound is drive. This does not indicate a fault. heard from - mechanism. • No operation can In the following cases, it will take more time than usual be performed until operation is possible: because the • Immediately after a disc or card is inserted. ACCESS/PC or • When a long time has elapsed since the camcorder was CARD ACCESS turned off last. indicator on this • When the temperature is greatly different from the camcorder remains status of previous recording. - lit or flashing. • When a scratched or dirty disc is inserted. • After a disc or • When the camcorder is subjected to strong vibrations. card is inserted, it • When the battery or DC power cord was disconnected takes some time before turning the power switch off. until recording is possible. No image appears on • Is the camcorder set to sleep mode? the LCD screen. Press QUICK START to release sleep mode. • In playback mode, did the last scene viewed end in a wipe to black edit? Press . • Is camcorder connected to a PC? Unplug the USB cable. 41, 106, 131 Additional Information 166