IBM 7979B1U User Manual - Page 26
CD/DVD-eject
View all IBM 7979B1U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
information panel. Power-on LED Hard disk drive activity LED Information Release LED latch Power-control button System locator LED System-error LED The following controls, LEDs, and connectors are on the operator information panel: v Power-control button: Press this button to turn the server on and off manually. v Power-on LED: When this LED is lit and not flashing, it indicates that the server is turned on. When this LED is flashing, it indicates that the server is turned off and still connected to a power source. When this LED is off, it indicates that power is not present, or the power supply or the LED itself has failed. Note: If this LED is off, it does not mean that there is no electrical power in the server. The LED might be burned out. To remove all electrical power from the server, you must disconnect the power cord from the electrical outlet. Attention: In a dc power environment, only trained service personnel other than IBM service technicians are authorized to connect or disconnect power to the dc power supply. See the documentation that comes with each dc power supply. v Hard disk drive activity LED: When this LED is flashing, it indicates that a hard disk drive is in use. v System-locator LED: Use this LED to visually locate the server among other servers. You can use IBM Director to light this LED remotely. v Information LED: When this LED is lit, it indicates that a noncritical event has occurred. An LED on the light path diagnostics panel is also lit to help isolate the error. v System-error LED: When this LED is lit, it indicates that a system error has occurred. An LED on the light path diagnostics panel is also lit to help isolate the error. v Release latch: Slide this latch to the left to access the light path diagnostics panel, which is behind the operator information panel. USB connectors: Connect a USB device, such as USB mouse, keyboard, or other USB device, to either of these connectors. Video connector: Connect a monitor to this connector. The video connectors on the front and rear of the server can be used simultaneously. Hard disk drive activity LED: Each hot-swap hard disk drive has an activity LED. When this LED is flashing, it indicates that the drive is in use. Hard disk drive status LED: Each hot-swap hard disk drive has a status LED. When this LED is lit, it indicates that the drive has failed. When this LED is flashing slowly (one flash per second), it indicates that the drive is being rebuilt as part of a RAID configuration. When the LED is flashing rapidly (three flashes per second), it indicates that the controller is identifying the drive. CD/DVD-eject button: Press this button to release a CD or DVD from the CD-RW/DVD drive. 10 System x3650 Type 7979: User's Guide