IBM 7979B1U User Manual - Page 61
Removing, Remote, Supervisor, Adapter, SlimLine
View all IBM 7979B1U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Removing a Remote Supervisor Adapter II SlimLine Note: Before you remove a Remote Supervisor Adapter II SlimLine, create a backup copy of the configuration so that if you are replacing the adapter, you can restore the configuration. Remote Supervisor Adapter II SlimLine Retainer bracket Latch bracket tabs To remove the Remote Supervisor Adapter II SlimLine, complete the following steps: 1. Read the safety information that begins on page vii and "Installation guidelines" on page 28. 2. Turn off the server and peripheral devices and disconnect all power cords and external cables (see "Turning off the server" on page 13). Attention: In a dc power environment, only trained service personnel other than IBM service technicians are authorized to connect or disconnect power to the dc power supply. See the documentation that comes with each dc power supply. 3. Remove the cover (see "Removing the cover" on page 31). 4. Remove the PCI riser-card assembly. 5. Spread the tabs of the latch bracket apart and lift the end of the Remote Supervisor Adapter II SlimLine, until the tabs release the adapter; then, slide the other end of the Remote Supervisor Adapter II SlimLine out of the retainer bracket. 6. Lift the Remote Supervisor Adapter II SlimLine out of the server. 7. Replace the PCI riser-card assembly. If you have other optional devices to install or remove, do so now. Otherwise, go to "Completing the installation" on page 81. Chapter 2. Installing optional devices 45